Author: Barham H. Ali
Abstract: The impact of using recycled waste expanded polystyrene foams (EPS), as a lightweight fill material by mixing with river sand were presented in this study. The waste EPS were thermally modified. The modified expanded polystyrene (MEPS) were gained by putting the waste EPS into an oven at 130°C for 15 minutes. The California Bearing Ratio (CBR) values of sand mixed with MEPS was studied. To conduct the test, five series of specimens were prepared that have a replacement of MEPS by weight which were 0%, 5%, 10%, 15%, and 20%. For each ratio CBR test were conducted. Unsoaked condition was used to perform the tests. By increasing the percentage of MEPS the values of CBR of the mixture were decreased. However, the minimum CBR value at 20% MEPS is still within subbase tolerance. Results of the tests demonstrate that addition of 20 % MEPS in sand makes the reduction of the density of mixture almost 50 %. MEPS can be an alternative light weight fill material for geotechnical application such as embankment of abutments.
Keywords: River Sand, Lightweight Fill, Geofoam (EPS), Unit Weight, Recycling Waste, California Bearing Ratio (CBR)
Download the PDF Document from here.
Eldin, N. N., & Senouci, A.B. (1992). Use of scrap tires in road construction. J. of Construction Engineering and Management, 118(3), 561-576.
Frascoia, R. I., & Cauley, R. F. (1995). Tire chips in the base coarse of a local road, Proc. of the Sixth Int. Conf. on Low-Volume Roads. Vol. 2, Transportation Research Board, Washington D.C., pp. 47-52.
Humphrey D.N., Whetten, N., Weaver, J., Recker, K., & Cosgrove, T. A. (1998). Tire shreds as lightweight fill for embankments and retaining walls. Proc. of the Conf. on Recycled Materials in Geotechnical Applications, ASCE, pp. 51-65, 1998.
Humphrey, D. N., & Sandford, T. C. (1993). Tire chips as lightweight subgrade fill and retaining wall backfill, Proc. of the Symposium on Recovery and Effective Reuse of Discarded Materials and By-Products for Construction of Highway Facilities. Federal Highway
Administration, pp. 5-87 to 5-99.
Humphrey, D.N., & Maion, W. P. (1992). Properties of tire chips for lightweight fill. Proc. of the Conf. on Grouting, Soil Improvement, and Geosynthetics, 2, ASCE, 1344-1355.
Kan, A., & Demirboga, R. (2009a). A new technique of processing for waste- expanded polystyrene foams as aggregates. Journal of Materials Processing Technology, 209, 2994–3000.
Kan, A., & Demirboga, R. (2009b). A novel material for lightweight concrete production. Cement & Concrete Composites, 31, 489–495.
Yoon, S., Prezzi, M., Siddiki, NZ., & Kim, B. (2006). Construction of a test embankment using a sand–tire shred mixture as fill material. Waste Management, 26(9), 1033-1044.